After placing the lamp stably, open the supporting foot components on both left and right sides to a 120-degree angle, then open the connecting rod of the right supporting foot, and lock the connecting rod of the right foot by pulling up the U-shaped bolt of the left supporting foot. Pull the lamp head lifting rod to the vertical state, and it will lock automatically (to unlock, pull up the iron piece at the bottom of the lamp rod). Then stand up the lamp head, which can rotate 360 degrees horizontally and flip 135 degrees vertically. The lamp rod is telescopic in two sections, with a maximum height of 1.2 meters, and each section corresponds to a pressure ring that can fix the height of the lamp rod.

After adjusting the height of the lamp head, press the red button on the box to turn on the light, and the order is floodlight → spotlight → flood-spotlight combination. Then adjust the irradiation angle and direction of the lamp head according to actual needs. The black button can adjust the conversion between strong light and weak light, and the blue button can turn on the warning light on the back of the lamp head. Press and hold the red button for 3 seconds to turn off the light in any state. During charging, the indicator light flashes gradually, and the indicator light is fully on when fully charged. Please check the remaining power (the number of power display lights when turned on) before using the lamp, and charge it in time when the power is low.

Please avoid looking directly at the light source for a long time to prevent eye damage. Do not use a pressure washer to clean the product, and do not modify the lamp in any way to avoid safety hazards.

It is suitable for small-scale construction, equipment maintenance, emergency rescue and other scenarios that require mobile lighting.